Two AP903's upgraded to v1.4.8 - neither of them will let me logout cleanly now. In both cases the top frame of the page breaks and essentially locks up.

It's not a big deal as you can just close the page and reload if needed - but you'd think somebody might have spotted this before release...

Hi,

Does the Channel Load, in the dashboard, on 1.4.8, look ok ?
I upgraded a couple of AP912C, from 1.4.7 to 1.4.8 and the Channel Load, showed 5GHz at Heavy 98%, rolled back to 1.4.7 and it changed back to Light 1%

regards

Colin

That appears fine for me.

Both my AP's are in 'AP' mode, one is wired the other is WDS.

Ok thanks, I have seen elsewhere that https: access is broken with 1.4.8, http: still works.

regards

Colin

Hmmm, I have HTTP enabled but with the 'Enforce HTTPS Access' checked. Since it's working 'close-enough' I'm not gonna risk changing that to just HTTPS.

The release notes have now been revised with this: -

Known Issue
 Web access via HTTPS doesn't work well after the firmware upgrade. It is recommended
to use HTTP instead or use either of the methods below to fix this problem temporarily.
(a) Enable "Enforce HTTPS Access" on web System Maintenance >> Management.
(b) Use "https://{IP}/login.asp" to access web. (Add "/login.asp" manually after IP. For
example: "https://192.168.1.11/login.asp")