Hi

I have set up a new Vigor 2926 router and replicated as far as I can tell all the settings from the old 2830

However where the host to LAN VPN users could previously access the internet through the Draytek's remote gateway no this doesn't seem to work. The remote users don't seem to have a Default Gateway in their VPN IP settings and I can't see where to specify this on either the router or in the Draytek Smart VPN client

Any help would be most appreciated!

Thanks

Just worked out that there is a bug on the 2926 (on this firmware at least) in that if Hardware Acceleration is enabled then Dial-In Users are unable to route to the Internet via the VPN tunnel using ‘Use default gateway on remote network’

Disabled Hardware acceleration and all is well again.

That's scary. Are there other things known to fail with 'hardware acceleration' enabled?