DrayTek UK Users' Community Forum

Help, Advice and Solutions from DrayTek Users

Site to site ipsec proxy problem

  • tarmac
  • Topic Author
  • Offline
  • New Member
  • New Member
More
17 Dec 2010 11:32 #65290 by tarmac
Site to site ipsec proxy problem was created by tarmac
Hi,

We have a problem in setting up a site to site vpn with one of our customers (we have an IPPBX2820n):

1) They want us to use public ip addresses for the vpn traffic (presumably to guarantee uniqueness) and IPSec as the tunnel.
2) I acquired extra ip addresses from our ISP and set up the 2nd ip address in LAN>>General Setup with the relevant start address and subnet mask, configuring it to be routable.
3) Configured a PC in our Lan to use one of the public addresses and tested for internet connectivity etc.
3) Configured the VPN IPSec General and Lan to Lan properties.
4) Did a bit of surfing and research and configured the vpn 2ndsubnet and
vpn pass2nd commands to on in the router.

However when we try to connect, although we get level 1 authentication the tunnel fails because our router is supplying the proxy address of our (NAT) 1st IP subnet.

Has anyone any experience with this - or even a resolution?

Thanks

Please Log in or Create an account to join the conversation.

Moderators: ChrisSami