DrayTek UK Users' Community Forum

Help, Advice and Solutions from DrayTek Users

LAN to LAN - 2800 to NETGEAR DG834

  • ldoodle
  • Topic Author
  • Offline
  • New Member
  • New Member
More
11 Aug 2010 11:07 #63277 by ldoodle
LAN to LAN - 2800 to NETGEAR DG834 was created by ldoodle
Hiya,

I have a 2800 one end and a DG834 the other. I'm trying t configure LtoL VPN but it's just not working.

The 2800 has a LOT more options than the DG834 so it must be the way it's configured.

Has anyone managed to get this woking with these 2 routers?

Please Log in or Create an account to join the conversation.

More
11 Aug 2010 14:24 #63282 by j.baker
Replied by j.baker on topic LAN to LAN - 2800 to NETGEAR DG834
I dont have a 2800 but I hav a 2820 that is connected to a DG384.

The remote DG384 is using dynamic DNS, as it does not have a fixed IP. I initiate a connection from my 2820 on demand.

Draytek VPN
3DES with authentication
IKE Phase 1 = Main Mode
IKE phase 1 = 3DES_SHA1_G2
IKE Phase 2 = 3DES_SHA1
IKE phase 1 lifetime = 14400
IKE phase 2 lifetime = 14400
Local ID = FQDN on router (EG router.foobar.com)

Netgear
Remote VPN Endpoint = FQDN (which needs to be the same as the Local ID above)
mode = main mode.
Local Identity Type = WAN IP Address
Remote Identity Type = IP Address
IKE responder only
Enable PFS
SA Life Time needs to be the same at each end (I use 14400)

Regards

John Baker


Vigor2820 series with firmware 3.3.5.2_RC2
ADSL

Please Log in or Create an account to join the conversation.

  • ldoodle
  • Topic Author
  • Offline
  • New Member
  • New Member
More
18 Aug 2011 10:08 #69067 by ldoodle
Replied by ldoodle on topic Re: LAN to LAN - 2800 to NETGEAR DG834
I know it's a bit late to reply (!), but I never got this working.

Can anyone shed some more light into this? I.e. what DH settings should be used on the NETGEAR side (i'd like to have both directions configured, not just out of one and in for the other).

Thanks

Please Log in or Create an account to join the conversation.

Moderators: ChrisSami