DrayTek UK Users' Community Forum

Help, Advice and Solutions from DrayTek Users

LAN to LAN connection works one way OK but not the other

  • murraymr
  • Topic Author
  • Offline
  • Junior Member
  • Junior Member
More
26 Jan 2010 18:27 #60072 by murraymr
2 Vigor 2820n are set up with a LAN to LAN link. From one site - call it Site A - you can ping the router and PCs at the other, and set up and use network places. From the other site (Site B) - nothing! I have tried disabling firewalls and adding the router IP address of Site A to Trusted Sites, to no avail.

Can anyone tell me what I have missed? I am sure it is staring me in the face! :)

Murray

Please Log in or Create an account to join the conversation.

More
26 Jan 2010 19:31 #60078 by njh
What are your LAN subnets and what have you put in your LAN-LAN profiles?

2900Gi/v2.5.6; 2900/v2.5.6

Please Log in or Create an account to join the conversation.

  • murraymr
  • Topic Author
  • Offline
  • Junior Member
  • Junior Member
More
26 Jan 2010 19:57 #60079 by murraymr
Sorry, I am not very clear what you mean. The subnets are 192.168.1.1 (the router) to 192.168.1.n and 192.168.2.1 (the router) to 192.168.2.n. Both routers were configured as dial out, using the static IPs from the ISP.

One more thing - the connection can only be made from Site A.

Murray

Please Log in or Create an account to join the conversation.

More
26 Jan 2010 20:29 #60081 by njh
Can you check what you have put in section 4 of your LAN-LAN profile on each router. Have you by any chance got an incorrect subnet mask at one end?

FWIW, one router should be configured as dial-in and the other as dial-out. You will be able to set the Always On at the dial-out end. At the dial-in end set the Idle Timeout to 0. This should make no difference to your ping problem.

2900Gi/v2.5.6; 2900/v2.5.6

Please Log in or Create an account to join the conversation.

  • murraymr
  • Topic Author
  • Offline
  • Junior Member
  • Junior Member
More
26 Jan 2010 21:52 #60084 by murraymr
The screen prints I have show that in Section 4 My WAN IP and Remote Gateway IP are set to the default 0.0.0.0, and the Remote Network IP is the router's IP address i.e. 192.168.1.1 or 192.168.2.1. The subnet mask I must check against the LAN section tomorrow, but they are currently the same - 255.255.255.0.

I will change one end to dial-in and change the Idle Timeout to 0. The other end I will set to Always On.

The RIP Direction is set to RX/TX Both and 'from first subnet to remote, you have to do' is set to NAT.

Many thanks for your help!

Murray

Please Log in or Create an account to join the conversation.

More
26 Jan 2010 22:25 #60085 by njh
I dont know anything about RIP - I have not found it do anything useful so I turn it off.

For your Remote Network IP's can you try 192.168.1.0 and 192.168.2.0? I have seen something saying this can matter ('though it is illogical!).

2900Gi/v2.5.6; 2900/v2.5.6

Please Log in or Create an account to join the conversation.

Moderators: ChrisSami