DrayTek UK Users' Community Forum

Help, Advice and Solutions from DrayTek Users

Site to site VPN static IP

  • baconface
  • Topic Author
  • Offline
  • New Member
  • New Member
More
02 Jun 2009 13:36 #56164 by baconface
Site to site VPN static IP was created by baconface
we're getting IP conflicts on our network. it appears that the VPN connection from another site is grabbing an IP that used for a printer.

Is there anyway I can set the VPN link so that the router on the other end uses a specific IP? when I run arp -a on the local LAN is shows our Draytek 2800 using 2 IP's on the same MAC address: xxx.xxx.xxx.1 - router IP and xxx.xxx.xxx.202 as the VPN. Ideally we've like to shift this to another IP address higher up in the /24 range.

Please Log in or Create an account to join the conversation.

More
02 Jun 2009 18:02 #56168 by njh
Replied by njh on topic Site to site VPN static IP
The different ends of the VPN tunnel should be on different subnets. It sounds like yours are on the same.

2900Gi/v2.5.6; 2900/v2.5.6

Please Log in or Create an account to join the conversation.

More
02 Jun 2009 21:45 #56172 by macavity
Replied by macavity on topic Site to site VPN static IP
There is some control over the .20x address. The start range can be set via VPN -> PPP General Setup

Each PPTP VPN uses the next IP available in that range, 202,203,204 etc.

Look for a free range of 16 addresses and set the start IP as the first ip.

Please Log in or Create an account to join the conversation.

  • baconface
  • Topic Author
  • Offline
  • New Member
  • New Member
More
05 Jun 2009 10:50 #56208 by baconface
Replied by baconface on topic Site to site VPN static IP
Thanks guys. I just needed to change the VPN start address and all is well now :)

Please Log in or Create an account to join the conversation.

Moderators: ChrisSami