Hi guys,

I have a Vigor 2865. For some reason when I try and login from HTTP or HTTPS on the LAN or WAN side it fails as it asks for a code (see image 1).

Image 1
https://ibb.co/jZgpGY5

I suspect that somehow the option System Maintenance\Administrator Password Setup\ "Enable Advanced Authentication method" (see image 2) has been accidentally enabled but not configured correctly.

Image 2
https://ibb.co/SmMtbwv

So on logging in it attempts to request a form of 2FA/MFA which has not been configured and therefore rejects any login attempts. As such, I can't login in to the web interface.

I can access the Draytek Vigor 2865 via telnet though. Can I disable System Maintenance\Administrator Password Setup\ "Enable Advanced Authentication method" via telnet? If not, do you have any other suggestions as to how I can regain access to the web interface of the Vigor 2865.

Many thanks in advance!

PT

Have you tried disabling the WAN login ? You can check the status using "mngt rmtcfg status" and then disable it using "mngt rmtcfg disable" ? And a re-boot for good measure. And the nucelar option is always a router reset with a manual re-config.