DrayTek UK Users' Community Forum

Help, Advice and Solutions from DrayTek Users

2860Ln - restrict video streaming to LTE

  • xtractorfan
  • Topic Author
  • Offline
  • New Member
  • New Member
More
03 Aug 2020 09:49 #96804 by xtractorfan
2860Ln - restrict video streaming to LTE was created by xtractorfan
Just recently purchased a 2860Ln to add to my Ubiquiti Unifi setup.
I have 2 broadband connections:
1. WISP - local provider ~10Mbps, but unreliable (download speed 'slumps' in the evening as more people use it) via Ubiquiti NanoBeam connected into Vigor WAN2 - dynamic, shows as 192.168.9.225 in the Vigor Dashboard.
2. Vodafone 4G using 2860 LTE (again variable download speeds, generally 10 - 25Mbp) DHCP, shows as 10.216.123.28 in the Vigor Dashboard.

I've set 2860Ln LAN1 as 192.168.10.1/24 and enabled the DHCP server.
This connects to the USG WAN port, which subdivides to 2 nets 192.168.1.0/24 (goes to my neighbour across the valley via 1Km Wi-Fi link) and mine 192.168.2.0/24.
I have a CloudKey controller and a few Unifi AP's.

The 2860 is set to Load Balance, Auto Weight and session based and all seems to work well :D

Apart from when I access say NowTv or Amazon Video it invariably defaults to the WISP on WAN2 - which after 8pm is dire.....
I've tried several things in the Load-Balance/Route Policy settings without success.

I suppose I want to restrict my Roku (static IP 192.168.2.61) to just use the LTE WAN.
Any ideas folks?
Thanks

Please Log in or Create an account to join the conversation.

More
03 Aug 2020 18:03 #96805 by netjet1980
Replied by netjet1980 on topic Re: 2860Ln - restrict video streaming to LTE
Use load balance routing policy for the roku ip. You can set a specific wan for the source ip. It should then ignore the load balancing for this ip.

Please Log in or Create an account to join the conversation.

  • xtractorfan
  • Topic Author
  • Offline
  • New Member
  • New Member
More
03 Aug 2020 20:36 #96806 by xtractorfan
Replied by xtractorfan on topic Re: 2860Ln - restrict video streaming to LTE
OK, tried that, but using my laptop (192.168.2.206) instead of the Roku:



When I Diagnose/Analyze - I get this:



If I go to Amazon Prime video and watch a movie, checking on the Vigor Diagnostics > Traffic graph all the throughput is still WAN2 not LTE.
So I guess as the subnets are 'split' after the 2860 it doesn't recognise the source?.....

Please Log in or Create an account to join the conversation.

Moderators: ChrisSami