DrayTek UK Users' Community Forum

Help, Advice and Solutions from DrayTek Users

2926 and 2860 WDS Problems

  • icmc
  • Topic Author
  • Offline
  • Junior Member
  • Junior Member
More
31 Jul 2019 12:15 #94795 by icmc
2926 and 2860 WDS Problems was created by icmc
Hi all

So far so good. I have the units connected via WDS on 5GHz but have a problem with the wider setup.
What I want to achieve
Using only the 2926ac it works as follows
I have 3 SSID's on 2.4GHz and 1 SSID on 5GHz. Also LAN1 one is strict bind and set to LAN1

I have set up a VLAN where I have in
VLAN0 P1 P2 and SSID 1 and 2 on 2.4 and SSID 1 on 5GHz
VLAN1 P3 and SSID 3
VLAN2 P4 no SSID
When connecting to SSID 3 it will change the IP address to 192.168.2.x which is exactly what I want
Connecting to SSID 1 and 2 it connects to IP address 192.168.1.x. So this works fine

I have now set-up the 2860 as follows both units are on 5GHz WDS and work as repeater. The connect fine

The problem I have now is that if on 2860 no VLAN's are set-up all SSID's connect but use 192.168.1x also for SSID3 which I don't want
If I set-up 2860 with VLAN's as I did on the 2926 the problem is that SSID 1 and 2 on 2.4GHz and SSID1 on 5GHz will connect correctly but if I connect to SSID3 it will connect to Network but will not give me internet access.
What am I doing wrong?

Your help is much appreciated

Thx
Ian

Please Log in or Create an account to join the conversation.

Moderators: ChrisSami