DrayTek UK Users' Community Forum
Help, Advice and Solutions from DrayTek Users
How to achieve "ip route default" with 2952?
- tgold
- Topic Author
- Offline
- Junior Member
Less
More
- Posts: 45
- Thank you received: 0
01 Apr 2018 01:06 #91232
by tgold
How to achieve "ip route default" with 2952? was created by tgold
With my previous Vigor routers I used the console commands "ip route default wan1/wan2/off" to send all outward traffic through one particular WAN while the other WAN was always on for incoming connections but was only used in failover for outgoing sessions. I find those commands have been deleted in the 2952 and ask how to achieve the same result with the newer command set? Thanks.
Please Log in or Create an account to join the conversation.
- admin
- Offline
- Site Admin
Less
More
- Posts: 1723
- Thank you received: 0
01 Apr 2018 22:43 #91238
by admin
Forum Administrator
Replied by admin on topic Re: How to achieve "ip route default" with 2952?
Not sure, but the 2952 is still DrayOS so it may be the facility is still/only available in the GUI (I don't have a V2952 to check). otherwise, ask support.
Forum Administrator
Please Log in or Create an account to join the conversation.
- admin3
- Offline
- Site Admin
Less
More
- Posts: 604
- Thank you received: 0
03 Apr 2018 14:46 #91253
by admin3
Forum Administrator
Replied by admin3 on topic Re: How to achieve "ip route default" with 2952?
To achieve that with current router models, you can now use the [Load Balance / Route Policy] rules to have all outbound traffic go over one WAN interface except when failing over - with route policy, you can also control the failover & failback (session handling on WAN reconnection) options.
Here's a guide on how to configure that:
Policy Routing with Metrics - Load Balancing, Address Mapping and VPN Routing
Here's a guide on how to configure that:
Forum Administrator
Please Log in or Create an account to join the conversation.
- tgold
- Topic Author
- Offline
- Junior Member
Less
More
- Posts: 45
- Thank you received: 0
03 Apr 2018 19:41 #91257
by tgold
Replied by tgold on topic Re: How to achieve "ip route default" with 2952?
Thanks for the pointer to the configuration guide. I'll try out some test settings to see if I can get the behaviour I want.
Please Log in or Create an account to join the conversation.
Moderators: Chris, Sami
Copyright © 2024 DrayTek