DrayTek UK Users' Community Forum

Help, Advice and Solutions from DrayTek Users

Unable to connect to Vigor 130

  • cezmunsta
  • Topic Author
  • Offline
  • New Member
  • New Member
More
28 Nov 2017 13:24 #90082 by cezmunsta
Replied by cezmunsta on topic Re: Unable to connect to Vigor 130
The line is fine, I cannot test the Vigor as a modem other than via my router or laptop, but the existing modem works on the router WAN port (but uses static addressing rather than the route dialling PPoE).

I have tried 2 RJ45 leads, one of my own (which works for other connections) and one that came with the unit. The odd thing is that I am pretty sure that the DSL light is solid even when I don't connect it to the line, but I'm trying to leave big enough gaps in between tests to avoid issues with the exchange seeing frequent disconnects.

Please Log in or Create an account to join the conversation.

More
28 Nov 2017 14:42 #90083 by adrianh54
Replied by adrianh54 on topic Re: Unable to connect to Vigor 130
From the quick set up guide.

LED Status Explanation :


ACT :
Off | The system is not ready or has failed.
Blinking | The system is ready and operating normally.

LAN :
On | Ethernet LAN (RJ45) is connected.
Off | Ethernet LAN is disconnected.
Blinking | Data is transmitting (sending/receiving).


DoS : | n/a This LED has no function in bridge mode currently.

DSL :
On | DSL connection synchronized.
Blinking | DSL connection is synchronizing.

Please Log in or Create an account to join the conversation.

  • cezmunsta
  • Topic Author
  • Offline
  • New Member
  • New Member
More
28 Nov 2017 16:57 #90085 by cezmunsta
Replied by cezmunsta on topic Re: Unable to connect to Vigor 130
Yes..
Code:
On | DSL connection synchronized
 seems to have no distinction from no DSL connected, at least it is solid with only power and RJ45 :D

Please Log in or Create an account to join the conversation.

More
28 Nov 2017 17:57 #90086 by adrianh54
Replied by adrianh54 on topic Re: Unable to connect to Vigor 130

cezmunsta wrote: Yes..

Code:
On | DSL connection synchronized
seems to have no distinction from no DSL connected, at least it is solid with only power and RJ45 :D



Aha ...... so the Vigor is faulty.

The LED display as per you OP should indicate a working unit . If the DSL light is always solid something is wrong.

Please Log in or Create an account to join the conversation.

  • cezmunsta
  • Topic Author
  • Offline
  • New Member
  • New Member
More
30 Nov 2017 11:28 #90104 by cezmunsta
Replied by cezmunsta on topic Re: Unable to connect to Vigor 130
Something was indeed wrong with the device. In the end, Support suggested flashing via TFTP and this has resolved the issue

Please Log in or Create an account to join the conversation.

Moderators: Chris