Hello,

This is my first post on this forum and probably not the last one. We are upgrading our hardware infrastructure. I was given to configure Vigor 2960 to configure our two bonded DSLs connections as WAN1 and WAN2.

ISP has added NAT to connection and I was given two IP addresses one for the vrrip wan interface, another one for firewall. Which if tabs should I use to set it up ?

Based on my experience with different routers I set it up that we however it did





Then I setup LAN interface - can I link LAN interface with specific port ? Nothing too difficult /20 wide pool for whole site.



Then I setup routing - but what IP/ mask should I use ???



How to link LAN interface with specific LAN port ?

What I am doing wrong, as I cannot see any 'incoming' traffic to the router ?