DrayTek UK Users' Community Forum

Help, Advice and Solutions from DrayTek Users

2960 firewall rules - IP Source = ANY

  • cw1972
  • Topic Author
  • Offline
  • New Member
  • New Member
More
18 Jun 2014 15:53 #80341 by cw1972
Hi all,

I've just bought a second 2960 as a backup to a 2960 I have in a datacentre, I backed up my config from my original and restored it to the new, all went well.

Then I was going through the config to check that it had all been applied and I see they have tweaked the interface between the 1.0.6 and 1.07.1 firmwares, the biggest concern I have is that when creating firewall rules I cannot seem to set the Source IP Address as ANY, it seems to be completely controlled by IP OBJECT and IP GROUP, if I go to define an IP OBJECT I get the choice of Single / Range / Subnet - so if I leave the source blank is that going to be the equivalent of Source = ANY?

Are my firewall rules going to work?

(I did try and downgrade the firmware but it wouldn't allow me).

Any information would be much appreciated.

Many thanks,

Christian

Please Log in or Create an account to join the conversation.

Moderators: ChrisSami