DrayTek UK Users' Community Forum

Help, Advice and Solutions from DrayTek Users

Vigor 3200N no TX packets on WAN

  • the-swede
  • Topic Author
  • Offline
  • New Member
  • New Member
More
21 Dec 2011 14:32 #70535 by the-swede
Vigor 3200N no TX packets on WAN was created by the-swede
Stumbling in the dark and never stumbled upon this issue.

Online status report NO TX packets sent at all, i do get RX and DHCP resolves just fine to my ISP, all info is passe dinto the lan, but no packets what so ever is passed from LAN -> WAN hence the no TX in the online status report.

Firmware 3.3.7 .
Brand new .
ANYONE had anything similar to this nonsence?

Please Log in or Create an account to join the conversation.

  • the-swede
  • Topic Author
  • Offline
  • New Member
  • New Member
More
22 Dec 2011 08:27 #70539 by the-swede
Replied by the-swede on topic Re: Vigor 3200N no TX packets on WAN
To answer my own Q i stumbled over the issue.
ANd if anyone else stumbles onto same issue.

My ISP provider aggregates traffic over multiple routers, some devices can see the packets as being "Spoofed", To enable your connection to run at Optimal Speed, then you will need to turn this feature off. To do so follow the below instructions:

1) Telnet to your router

2) Check the status using the following command:

router> ip arp accept status
current status: disable

If the router returns disable as above then you will need to run the following command:

router> ip arp accept 1
Accept illegal ARP REPLY packets.

Now to check the status re-run the command:

router> ip arp accept status
current status: enable


Case closed

Please Log in or Create an account to join the conversation.

Moderators: ChrisSami