DrayTek UK Users' Community Forum

Help, Advice and Solutions from DrayTek Users

Remote Access

  • davewebster1
  • Topic Author
  • Offline
  • New Member
  • New Member
More
12 Dec 2011 15:37 #70442 by davewebster1
Remote Access was created by davewebster1
I have been trying to set port 443 so that I can access my NAS from the internet. I have set the port with a private IP and DDNS which allows me to access the router from the DDNS name on the LAN but not WAN. Any help would be welcome. :D

Please Log in or Create an account to join the conversation.

More
12 Dec 2011 17:14 #70445 by nealuk
Replied by nealuk on topic Re: Remote Access
Is the vigor remote management already configured to use 443? If so put it on something else... such as 8443 and then your rules should kick in.

Please Log in or Create an account to join the conversation.

  • davewebster1
  • Topic Author
  • Offline
  • New Member
  • New Member
More
13 Dec 2011 09:36 #70450 by davewebster1
Replied by davewebster1 on topic Re: Remote Access
The remote managment is enabled but can't see how to check what port it is configured to. Could you advise?

Please Log in or Create an account to join the conversation.

More
13 Dec 2011 11:24 #70451 by drummerjohn
Replied by drummerjohn on topic Re: Remote Access
System Maintenance >> Management -> Management port setup

Please Log in or Create an account to join the conversation.

More
15 Dec 2011 10:02 #70468 by howard simpson
Replied by howard simpson on topic Re: Remote Access
You don't mention which version of the firmware you are using. I use port forwarding for my NAS box and a wireless access point. The port forwarding to the NAS box stopped working with the last firmware but not to the AP! However with the latest firmware it is now working again!

Howard

Please Log in or Create an account to join the conversation.

Moderators: ChrisSami