DrayTek UK Users' Community Forum

Help, Advice and Solutions from DrayTek Users

2600 VLAN OK button dead

  • iwrconsultancy
  • Topic Author
  • Offline
  • Junior Member
  • Junior Member
More
11 Nov 2011 15:46 #70033 by iwrconsultancy
2600 VLAN OK button dead was created by iwrconsultancy
Vigor 2600 Plus, also have a 2600G, both using firmware 2.5.9 UK. Firefox 6 used to config.

On the 'Wired VLAN Setup' config page, the OK button does nothing, and the changes are not saved.

If no ports are selected, pressing OK does give an error message. But, with a correct selection of ports, pressing OK does nothing at all. Reloading the page after pressing OK shows that no changes were saved.

Does anyone know if this is a bug in the 2.5.9 firmware, and/or if there is any workaround?

Please Log in or Create an account to join the conversation.

  • iwrconsultancy
  • Topic Author
  • Offline
  • Junior Member
  • Junior Member
More
12 Nov 2011 19:54 #70045 by iwrconsultancy
Replied by iwrconsultancy on topic Re: 2600 VLAN OK button dead
No ideas on this?

Have tried 2.5.7 and 2.5.9 UK2 firmware, identical result.

Have tried other browsers as well, but no joy.

The rate control page's OK button is likewise dead.

Find it hard to believe this isn't a firmware bug, as two routers behave identically.

Please Log in or Create an account to join the conversation.

More
12 Nov 2011 20:22 #70046 by NeilH
Replied by NeilH on topic Re: 2600 VLAN OK button dead
Have you tried IE instead. There have been comments before about using Browsers other than IE sometimes does not work.

Neil..

Please Log in or Create an account to join the conversation.

  • iwrconsultancy
  • Topic Author
  • Offline
  • Junior Member
  • Junior Member
More
12 Nov 2011 20:38 #70047 by iwrconsultancy
Replied by iwrconsultancy on topic Re: 2600 VLAN OK button dead

g6ifs wrote: Have you tried IE instead. There have been comments before about using Browsers other than IE sometimes does not work.
Neil..



You're right. Not only that, but it only works in SOME versions of IE. I'd tried that before but with no joy. Eventually in desperation took a test computer and tried a few different versions. Got it to work in IE7.

Thx.

Please Log in or Create an account to join the conversation.

More
16 Dec 2012 11:07 #74552 by dgcooke
Replied by dgcooke on topic Re: 2600 VLAN OK button dead

IWRConsultancy wrote:
You're right. Not only that, but it only works in SOME versions of IE. I'd tried that before but with no joy. Eventually in desperation took a test computer and tried a few different versions. Got it to work in IE7.
Thx.



Rate Control worked for me using IE9 but I had to set Compatibility View selectable from the Tools menu.

My setup is a Vigor 2600 plus and 2.5.9UK firmware.

Please Log in or Create an account to join the conversation.

Moderators: ChrisSami