DrayTek UK Users' Community Forum

Help, Advice and Solutions from DrayTek Users

2820 SNMP Setup

  • soulkiss
  • Topic Author
  • Offline
  • New Member
  • New Member
More
12 Oct 2010 13:07 #64222 by soulkiss
2820 SNMP Setup was created by soulkiss
Hi there.

I have a 2820 that I wish to monitor from an external server using SNMP

I have set up SNMP in the Management section of the UI Configurator and rebooted twice.

Telnetting in shows the following

SNMP Agent is [Enable].
Get Community is [public].
Set Community is
This message contains secure information

Please Log in or Create an account to join the conversation.

More
12 Oct 2010 13:39 #64224 by thrain
Replied by thrain on topic 2820 SNMP Setup
Change your SNMP strings to something that's a bit harder to guess than the standard ones :shock:

To check snmp download getif http://www.wtcs.org/snmp4tpc/getif.htm and try and query the WAN interface.

Please Log in or Create an account to join the conversation.

  • soulkiss
  • Topic Author
  • Offline
  • New Member
  • New Member
More
12 Oct 2010 14:14 #64226 by soulkiss
Replied by soulkiss on topic 2820 SNMP Setup

Thrain wrote: Change your SNMP strings to something that's a bit harder to guess than the standard ones :shock:

To check snmp download getif http://www.wtcs.org/snmp4tpc/getif.htm and try and query the WAN interface.



Well as this is still in testing and I AM publishing configs to the internet, I think that its probably right to just use the defaults. :)

To clarify, from a host on the Inside (LAN) of the router I cannot SNMP,WALK (using the standard Linux SNMP toolset) to either the LAN or WAN interfaces, both of which respond to PING/ICMP from inside.

From outside of the network (from the Amazon Cloud to be exact) is the same case, well limited to the WAN interface of course.

UPDATE: Tried GetIF now as well, still no luck.

Please Log in or Create an account to join the conversation.

More
12 Oct 2010 20:45 #64230 by gkirwan
Replied by gkirwan on topic Same Issue
I have three 2820's that I can not connect to using PTRG but I know the routers are ok as I have 5 others at the same site which I can monitor.

Please Log in or Create an account to join the conversation.

  • soulkiss
  • Topic Author
  • Offline
  • New Member
  • New Member
More
12 Oct 2010 21:42 #64232 by soulkiss
Replied by soulkiss on topic Re: Same Issue

GKirwan wrote: I have three 2820's that I can not connect to using PTRG but I know the routers are ok as I have 5 others at the same site which I can monitor.



What Firmware levels do you have?

If the 5 that work are on one then maybe there is a level of firmware that SNMP is broken in

Please Log in or Create an account to join the conversation.

Moderators: ChrisSami