DrayTek UK Users' Community Forum

Help, Advice and Solutions from DrayTek Users

IP Routing - how disable NAT

  • jmsdunn85
  • Topic Author
  • Offline
  • New Member
  • New Member
More
11 Nov 2009 13:20 #58776 by jmsdunn85
IP Routing - how disable NAT was created by jmsdunn85
Hello,

We have a setup as follows:

a.b.c.254
Draytek 2820
|x.y.z.1
|
|x.y.z.2
Cisco ASA 5510
|private
|
|private
Layer 3 switch

I simply want the Draytek to pass all traffic to the ASA for natting and routing. I do not want the Draytek to do anything intelligent.

I am sick and tired of how useless these routers are for anything other than home use. Can anybody tell me how on earth you assign a public address to the inside (LAN) interface of the draytek and get it to work?

I have a public /29 block that i want to use between the ASA and the draytek. I have enabled IP routing and have specified the publc network address for routing but I am unable to ping the ASA from internet. The ASA can ping the draytek.

Anybody can help?

Please Log in or Create an account to join the conversation.

More
11 Nov 2009 17:44 #58782 by macavity
Replied by macavity on topic IP Routing - how disable NAT
An explanation on how to configure non-nat usage is on
http://www.draytek.co.uk/support/kb_vigor_2ndsubnet.html

Please Log in or Create an account to join the conversation.

Moderators: ChrisSami