DrayTek UK Users' Community Forum

Help, Advice and Solutions from DrayTek Users

2950 failover not working

  • wilsonfiifi
  • Topic Author
  • Offline
  • New Member
  • New Member
More
13 May 2009 18:54 #55763 by wilsonfiifi
2950 failover not working was created by wilsonfiifi
Hi, I hav a draytek 2950 router with 2 wan connections setup.

But the failover only works when one of the wan cables is physically pulled out of the 2950 router.

However if any of the wan connections is actually down, no switching takes place. (this can be, simulated by turning off my ISP's router)

Thanks

Please Log in or Create an account to join the conversation.

More
16 May 2009 15:36 #55815 by louis-m
Replied by louis-m on topic 2950 failover not working
check your load balance policies. there are auto failover settings in the policies themselves which apply when "always on" is selected under general settings.

2820 = 3.3.2_RC5
2950 = 3.2.4

Please Log in or Create an account to join the conversation.

  • wilsonfiifi
  • Topic Author
  • Offline
  • New Member
  • New Member
More
17 May 2009 08:45 #55827 by wilsonfiifi
Replied by wilsonfiifi on topic 2950 failover not working
Thanks Louis-m, will give that a shot today and get back to you.
Client is getting a bit worried and frankly so was I (this is my 1st Draytek :) )

Please Log in or Create an account to join the conversation.

Moderators: ChrisSami