DrayTek UK Users' Community Forum

Help, Advice and Solutions from DrayTek Users

Vigor 2820 Load balancing question

  • zensupportteam
  • Topic Author
  • Offline
  • New Member
  • New Member
More
10 Mar 2008 13:22 #48149 by zensupportteam
Vigor 2820 Load balancing question was created by zensupportteam
Hi,

I am setting up a 2820n router to use both Wan interfaces.
WAN1 ADSL (6 public IP addresses), WAN 2 (1 public IP Address) via Vigor 2600G.

WAN 1
82.11.23.16 Wan IP alias 1 (Interface IP of wan1)
82.11.23.15 Wan IP alias 2
82.11.23.14 Wan IP alias 3
82.11.23.13 Wan IP alias 4
82.11.23.12 Wan IP alias 5
82.11.23.11 Wan IP alias 6

(not real IP address)

I would like to load balance traffic for my SIP PBX to go out of WAN 1 but on alias 2 (82.11.23.15) not alias 1 (82.11.23.16)

I have inbound mappings working correctly using "Open Ports" bound to alias 2 (82.11.23.15).

Question: will outbound traffic bind to alias 2 (82.11.23.15) or alias 1 (82.11.23.16) ?

There are no options in the load balancing rule other than what interface to use, you cannot select the source IP. The only option i have seen that may be relevant is the ability to add the Wan IP Alias to the NAT pool, but does this just allow any outbound traffic to pick an IP from the pool?

Any help would be appreciated.

Cheers

Neil
Zen Software Support

Please Log in or Create an account to join the conversation.

More
21 Jun 2010 21:48 #62439 by sleazybreezy
Replied by sleazybreezy on topic Vigor 2820 Load balancing question
hi,

i thnk you have to put an ip into dmz to enable outbound ip being the one you want.

Please Log in or Create an account to join the conversation.

Moderators: ChrisSami