How can I route SIP traffic via the WAN2?

I have just had another ADSL line installed from Spitfire for my SIP Trunks, but they don't offer a setup to do this.


Jeremy.

possible example 1:

Your local network is 192.168.0.1-254

You have the PC's between 192.168.0.1-199
You have the IP phones between 192.168.0.200-254

In load balance set source IP range 192.168.0.200-254 to go out over WAN2 with failover to the other WAN.

possible example 2:

Your IP phone data uses 5060-5082 for sip registrations and NAT.
Your IP phones use 16000-17000 vfor the audio traffic.

In load balance set destination port range 5060-5082 to go out over WAN2 with failover to the other WAN.
Also in load balance set destination port range 16000-17000 to go out over WAN2 with failover to the other WAN.

Regards,


Neal.