DrayTek UK Users' Community Forum

Help, Advice and Solutions from DrayTek Users

ISDN TRunk Settings

More
09 Aug 2011 22:52 #68971 by mpwox11
Replied by mpwox11 on topic Re: ISDN TRunk Settings
Are you sure the ISDN ports are configured as TE ports and not S0 ports? Even though the TE4P card is 4 x TE ports, I seem to recall when setting up the two IPPBX3510s I've installed, there were options to change the port setup.

Please Log in or Create an account to join the conversation.

More
10 Aug 2011 09:13 #68973 by spcc
Replied by spcc on topic Re: ISDN TRunk Settings
Yes they are configured as TE ports on the IPPBX2820 that I am using.

Please Log in or Create an account to join the conversation.

More
29 Aug 2011 16:42 #69163 by sysadmin
Replied by sysadmin on topic Re: ISDN TRunk Settings
Having problems with a a fresh install of a 3510 with the ISDN card. We had a ISDN system before and it packed in so we had to replace they system with something that is more expandable.
We have 3 ISDN2e with 40 MSNs over them.

I configured the system but I can not dial out, i only get connected for 7 secs (like previous postes) and then get disconnected.
Also no inbound calls.

Any help anyone can suggest other than
- making sure the ISDN is TE (according to IP PBX >> PBX System > Phone list it is.
- set all 3 lines to P-P
- enter the global MSN lists.

what else?

Thanks
Chris

Please Log in or Create an account to join the conversation.

Moderators: ChrisSami