DrayTek UK Users' Community Forum

Help, Advice and Solutions from DrayTek Users

Using all 4 ISDN Channels

  • boaber22
  • Topic Author
  • Offline
  • Junior Member
  • Junior Member
More
13 Apr 2011 16:46 #67264 by boaber22
Using all 4 ISDN Channels was created by boaber22
We have successfully tested the pbx using 4 ISDN channels at the once in our office.

However when we take the pbx down to a clients who recently had ISDN installed (4 channels, 2 BT Boxes same as ours) then we can only make use of 2 channels at a time.

In online status section in the pbx it says that the 2 Trunks (ISDN1-D and ISDN2-D) are UP.

Ive also made sure that in the digit map setting that ISDN1 is the primary route and ISDN2 is the backup route.

Does snyone have any suggestions as to why we can still only use 2 channels at a time?

is there something that needs done on BT's end?

Any input would be much appreciated

Please Log in or Create an account to join the conversation.

More
13 Apr 2011 16:56 #67265 by macavity
Replied by macavity on topic Re: Using all 4 ISDN Channels
Does it work outside digitmap?

First two calls dial 903 and then dial the destination numbe after hearing the isdn dial tone.

For call 3/4 dial 904

Please Log in or Create an account to join the conversation.

More
22 Apr 2011 09:39 #67417 by admin
Replied by admin on topic Re: Using all 4 ISDN Channels
Also, check if the lines are configured to point-to-point or point-to-multipoint mode.



Forum Administrator

Please Log in or Create an account to join the conversation.

Moderators: ChrisSami