DrayTek UK Users' Community Forum

Help, Advice and Solutions from DrayTek Users

how to configure QoS for VOIP ?

  • fabianus
  • Topic Author
  • Offline
  • New Member
  • New Member
More
30 Apr 2009 19:48 #55604 by fabianus
how to configure QoS for VOIP ? was created by fabianus
Hello all !

I have a Vigor 3300 V with latest firmware (2.5.9.0).
Behind this I have an Asterisk box and several clients with X-Lite.

I would like to setup QoS to secure the voip quality.
Here is what I did :

For Incoming and Outgoing classes I set :

1) Class Name : rtp
Bandwith : 90 %

2) Class Name : sip
Bandwith : 5 %

And for Incoming Class Filter I set :

1) no config for Source IP, Destination IP,
Service Type Status: Advanced
Protocol: TCP/UDP
Source Port: 10000 - 20000
Destination Port: 10000 - 20000
DiffServ CodePoint Status: Basic
DiffServ CodePoint Type: EF CLASS
Class: rtp-90%

2) no config for Source IP, Destination IP,
Service Type Status: Advanced
Protocol: TCP/UDP
Source Port: 5060 - 5060
Destination Port: 5060 - 5060
DiffServ CodePoint Status: Basic
DiffServ CodePoint Type: AF CLASS 3 (Low Drop)
Class: sip-5%

And for Outgoing Class Filter I set same as for Incoming.


I did test the voip quality by making a call and once the call established starting a heavy download, but the quality is not guaratied !

Thanks a lot for any feedback concerning this configuration and how to modify it in order to guaranty the quality of VOIP.

Regards,
Fabianus

Please Log in or Create an account to join the conversation.

More
14 May 2009 22:55 #55791 by lyquid
Replied by lyquid on topic DiffServ
The way you have the QoS setup is it's going to prioritize TCP/UDP packets on ports 10000-20000 that are DiffServ tagged EF class.

Most likely your packets are not tagged as DiffServ EF Class so you should disable that section of the rule, at which point the ACL will match the traffic you are trying to prioritize, and it will work.

Please Log in or Create an account to join the conversation.

Moderators: ChrisSami