I can't make mesh work. Brand new out the box: 2865ac, AP903, 2x AP802. One of the 802s appears faulty, flashes all LEDs continually, firmware doesn't change that so will be returned.
Remaining devices - straight out the box, firmware flashed, the only configuration done is to enable mesh. All three are on the bench next to each other (about a foot apart).
Mesh config in router UI is unresponsive at times, but mesh creates, nodes adopt and after a few minutes config goes to online (sync ready).
However, the mesh continually breaks. Some logs from the 802, the 903 is just as unstable:
Code:
May 13 22:30:28 AP802 local1.notice syslog: [dmn] dmn_pkt_recv Announce-Info from 14:49:BC:12:8C:D0
May 13 22:30:28 AP802 local1.notice syslog: [dmn] Disconnected by User.
May 13 22:30:28 AP802 local1.notice syslog: [dmn] dmn_pkt_send Declare-Offline
May 13 22:30:28 AP802 local1.notice syslog: [dmn] Uplink is deleted.
May 13 22:30:28 AP802 local1.notice syslog: [dmn] Delete WDS MAC 14:49:BC:12:8C:D0 on mesh0
May 13 22:30:28 AP802 local1.notice syslog: [dmn] Stop accepting Wireless clients.
May 13 22:30:28 AP802 local7.info kernel: (5G) Delete WDS 14:49:BC:12:8C:D0
May 13 22:30:28 AP802 user.warn kernel: [dmn] set listen mode to LOST
May 13 22:30:28 AP802 user.emerg kernel: >[dmn] set dmn_invite_list_detecting from 0 to 2 (none:0, INIT:1, LOST:2)
May 13 22:30:28 AP802 user.emerg kernel: >[dmn] Start detecting (0x00000017)(00:00:00:00:00:00)(0x02).
May 13 22:30:28 AP802 user.emerg kernel: >[dmn] Mesh IE Record (Backhaul) 00:1D:AA:40:08:68
May 13 22:30:28 AP802 user.emerg kernel: >[dmn] Backhaul from 00:1D:AA:40:08:68.
May 13 22:30:28 AP802 user.emerg kernel: >[dmn] Mesh IE Record (Backhaul) 14:49:BC:12:8C:D0
May 13 22:30:28 AP802 user.emerg kernel: >[dmn] Backhaul from 14:49:BC:12:8C:D0.
May 13 22:30:30 AP802 user.emerg kernel: >[dmn] Mesh IE Record (Backhaul) 00:1D:AA:40:08:68
May 13 22:30:30 AP802 user.emerg kernel: >[dmn] Mesh IE Record (Backhaul) 14:49:BC:12:8C:D0
May 13 22:30:31 AP802 user.info syslog: goahead SIGNAL(43) -> WPSRestart_All() +
May 13 22:30:31 AP802 user.emerg kernel: >[dmn] Mesh IE Record (Backhaul) 00:1D:AA:40:08:68
May 13 22:30:31 AP802 user.emerg kernel: >[dmn] Mesh IE Record (Backhaul) 14:49:BC:12:8C:D0
May 13 22:30:32 AP802 local1.notice syslog: [dmn] Mesh Node (Wireless Uplink) - Lost
May 13 22:30:32 AP802 local1.notice syslog: [dmn] Change state MeshNodeW -> MeshLostW.
May 13 22:30:33 AP802 user.emerg kernel: >[dmn] Mesh IE Record (Backhaul) 00:1D:AA:40:08:68
May 13 22:30:33 AP802 user.emerg kernel: >[dmn] Mesh IE Record (Backhaul) 14:49:BC:12:8C:D0
May 13 22:30:33 AP802 user.info syslog: goahead SIGNAL(43) -> WPSRestart_All() -
'2865 is on 4.2.4_BT, 903 is 1.4.0 and 802 tested with 1.4.1 and 1.4.0.
